Filter
Top Products
Page 16
8. Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in use
will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER:
Risk of injury, always check water temperature
carefully before entering spa!
Decontamination Procedure (Steps 9-15)
Steps 9-15 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable at 3 ppm to 5 ppm after performing steps 1-6 above.
9. Add 2.5 ounces of sodium dichlor for every 100 gallons of water.
Refer to the table below for approximate water ll volume by model.
CAUTION: Never add chlorine tablets (trichlor) to your
spa for any reason! This chemical may damage components
within your spa and void the manufacturer warranty.
Water Fill Volume by Model
Spa Model Approximate Fill Volume
Denali ........................................ 220 US Gallons (833 Liters)
Tacoma ...................................... 105 US Gallons (397 Liters)
Burlington .................................. 340 US Gallons (1,287 Liters)
10. Leave spa cover open during this step to allow excessive chemical
vapors to exit spa, protecting plastic knobs and pillows on Tacoma
and Burlington models from chemical attack. If spa is indoors, open
doors and windows for proper ventilation. Turn on all
spa jets pumps for one hour, open all air controls. On
Denali models, place the Divert-A-Jet in their center
“combo” position as shown (right). Note: You will need
to press the jets pump button(s) every 20 minutes since
these functions have an automatic 20 minute time-out
function that turns them off.
B