Page 15
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your autho
-
rized Sundance dealer. See section titled “WATER QUALITY
MAINTENANCE” (page 29) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3 ppm and 5 ppm
chlorine or 4 ppm and 6 ppm bromine. To ensure healthy water
conditions, always maintain a constant sanitizer reading within the
levels recommended by the Association of Pool And Spa Profession-
als/USA printed on the inside cover of this manual. If sanitizer levels
cannot be stabilized, perform the decontamination procedure steps
9-15 on the following page. Note: the “decontamination procedure”
steps 9-15 should also be used after the spa has been “Winterized”
(sec. 11.7) or has been sitting without power for an extended period.
7.
Set Spa To Heat
To warm spa water to a comfortable temperature, follow these
steps:
• The LCD display on the control panel displays the actual
temperature of the spa water. Press either the COOLER
(Down) or WARMER (Up) button once to display the “set”
temperature for 5 seconds. If you want the water to
heat to a different temperature, simply press COOLER
or WARMER within 5 seconds. The set temperature
increases or decreases by one degree each time one of these
buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum temperature for which the spa can be set is 104°F
(40°C) and the minimum is 80°F (27°C).
• For 2-pump Burlington modes powered by a 40 amp service, jets
pump #1 must be set to low speed and jets pump #2 must be
turned off to operate the heater.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed “set
temperature”, then turns off. The heater will reactivate after the
water cools to approximately 1.5° below the “set temperature.”