Filter
Top Products
Page 9
5.0 Power Requirements
Sundance® spas are designed to provide optimum performance and
flexibility of use when connected to the maximum electrical service listed
in the tables below. If you prefer, your dealer can perform a minor circuit
board modification to allow your spa to accept an electrical service other
than the factory setting.
US/Canada Denali/Tacoma 1-Pump Convertible Models (60Hz)
120V/15A* 240V/30A* 240V/40A**
Voltage: 120 VAC 240 VAC 240 VAC
# of Wires: 3 (15A GFCI Cord - 4 (Hard 4 (Hard
US Models Only*) Wired Only) Wired Only)
Frequency: 60Hz 60Hz 60Hz
Current Draw: 12A 21A 30A
Circuit Breaker: 15A, 1-Pole 30A, 2-Pole 40A, 2-Pole
For 240 VAC Heater Operation: Move the red wire on the main terminal
strip (TB1) from position #1 to position #3. Make certain wires are connected
exactly as shown in Figure-D (page 13)
before applying power. Failure to do
so will result in damage to the circuit board and/or related components and
void the manufacturer’s warranty.
* In the 15A/30A configuration, the heater
will not operate at the same
time as the high-speed jets pump.
The factory setting is 120V/15A.
Note: all Canadian spas must be hard wired (120 VAC or 240 VAC)
per CSA Canadian standards (page 4).
** If the spa is to be operated on 40A service, remove the jumper JP1
#1-2 on the circuit board to allow the heater to operate at the same time
as the high-speed jets pump (page 35).
US/Canada Burlington 2-Pump Models (60Hz)
240V/50A* 240V/40A**
Voltage: 240 VAC 240 VAC
# of Wires: 3 3
Frequency: 60Hz 60Hz
Current Draw: 36A 26A
Circuit Breaker: 50A, 2-Pole 40A, 2-Pole
*
In 50A configuration, the heater will not operate while both jets pumps
are running in high speed.
Note: pump 2 runs only in high speed. This is
the factory setting.
**
In 40A configuration, the heater will not operate while either jets pump is
running in high speed.
Note: pump 2 runs only in high speed.