Filter
Top Products
Page 19
B C D
E
F
G
A
8.0 Control Functions
8.1 Control Panel
A. LED Display: Can display
current water temperature
(default display), water
temperature set point,
selected filtration/heating
mode, and error
messages.
B. Heat Indicator: Lit when
heater is on.
C. Warmer ( + ) Button:
Increases water
temperature set point.
D. Cooler ( - ) Button: Decreases water temperature set point.
E. Jets 1 Button: Turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump off.
F. Light Button: Turns underwater light on and off.
G. Jets 2 Button (Burlington Models Only): Turns high-speed jets pump
#2 on and off. Press once to turn on; press a second time to turn
pump off.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• Underwater Light Operation: Light runs for 1 hour then shuts off for
increased bulb life.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes after
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.