Filter
Top Products
Page 41
ELITE SERIES
Expert winterization of your spa is highly recommended, contact your
authorized Sundance dealer. In emergency situations, damage can be
minimized by taking the following steps:
CAUTION: TURN OFF POWER TO HOT TUB!
1. Follow the directions on pages 37-38 for draining the spa.
2. Turn the massage/diverter selector(s) into the middle combo position
to allow the water in the plumbing lines to drain, see page 29.
3. As the water level drops below the seats, use whatever means
necessary to get the water out of the recessed seating areas and
into the footwell, such as a wet/dry vacuum.
4. When the water level ceases to drop, use whatever means available
to remove any remaining water from the footwell, such as a wet/dry
vacuum.
5. Remove the equipment-side cabinet panels and locate the drain
plugs in the front of the pump(s) (Figure A, page 14). Remove these
plugs to allow the water to drain out of the pumps and heater.
Note: Approximately one to two gallons will be released during this
procedure. Use a wet/dry vacuum or other means to keep this from
ooding the equipment compartment. Replace the drain plugs.
6. Loosen the hose clamp on the circulation pump intake behind the
control box (Figure A, page 14) and pull the hose off (twist hose back
and forth while pulling outward). Tip hose down and allow to drain,
then reinstall hose and clamp.
7. Re-install cabinet side panels and cover spa so that no casual
moisture can enter into it.
Consult your authorized Sundance dealer if you have any questions
regarding winter use or winterizing.
11.8 Restarting Your Spa in Cold Weather
If you want to start up your spa after it has sat empty for a time in
freezing temperatures, be aware that the water remaining in certain
sections of the piping may still be frozen. This situation will block water
ow preventing the spa from operating properly and possibly damaging
the equipment. We recommend you consult your dealer for guidance
before attempting to re-start your spa under these conditions.
11.9 Top Rail Care And Maintenance
Parts should be cleaned with soap and water and a non-abrasive
cleaning pad. More stubborn stains can be cleaned with a water based
cleaning solution or cleaners specied for vinyl surfaces. Solvent based