Page 35
ELITE SERIES
11.0 Spa Maintenance
Proper and regular maintenance of your spa will help it retain its beauty
and performance. Your authorized Sundance dealer can supply you with
all the information, supplies and accessory products you will need to
accomplish this.
DANGER: RISK OF SEVERE INJURY OR DROWNING
BY ENTRAPMENT!
Keep hair, loose articles of clothing or hanging jewelry away from •
suction ttings, rotating jets or other moving components to avoid
entrapment that could lead to drowning or severe injury.
Never use the spa unless all suction guards, lter, lter lid, or skimmer •
assembly are installed to prevent body and/or hair entrapment.
Never operate or use the spa if the lter, lter lid, or skimmer assembly •
are broken or any part of the skimmer assembly is missing. Please
contact your dealer or nearest service center for service.
The suction ttings and suction covers in this spa are sized to match •
the specic water ow created by the pump(s). If it is necessary to
replace the suction ttings, suction covers or pump(s), be sure that the
ow rates are compatible and are in compliance with the VGB Safety
Act page 2.
Never replace a suction tting or suction cover with one rated less •
than the ow rate marked on the original suction tting. Using improper
suction ttings or suction covers can create a body or hair suction
entrapment hazard that may lead to drowning or severe injury.
Owners must alert all spa users to the potential risk of Hair, Limb, •
Body, Evisceration (disembowelment), and Mechanical Entrapment,
page 6.
!
11.1 Cleaning The Filter
Your new spa is equipped with an exclusive MicroClean
™
2-stage
lter cartridge located under the lter lid. Fine debris are ltered by the
circulation pump drawing water through the ultra-ne (stage 2) cartridge.
Larger debris are ltered by the main 2-speed pump drawing water
through the (stage 1) polyester mesh (pleated) cartridge during normal
operation and during each ltration/heating cycle. Combined, both lter
halves work together to give you unsurpassed water quality by trapping
suspended particles on their outer surface.
Note: To ensure optimum performance, clean and reuse the stage
1 cartridge once a month and replace the stage 2 cartridge every 3
months, or as needed.