Filter
Top Products
25
Section 3 - OPERATING INSTRUCTIONSSection 5 - ADJUSTMENTS & REPAIR
5.8 ENGINE ADJUSTMENTS & REPAIR
Refer to the engine owner's manual for engine adjust-
ments and/or repairs.
5.9 MOWER BLADE REPLACEMENT
5.9.1. BLADE WEAR LIMITS
1. Inspect blade frequently for signs of excessive
wear or damage. Replace blade when it reaches the
wear limit. See Figure 5.14.
5.9.2. BLADE SHARPENING
1. Remove blade. See Figure 5.15.
2. Inspect condition of blade. See Figure 5.14.
3. If blade is in good condition, sharpen at 22 to 28
degrees. DO NOT sharpen beyond original cutting
edge. See Figure 5.16.
4. Check blade balance after sharpening. If neces-
sary, correct blade balance by grinding the heavy end
of blade.
IMPORTANT: Blade balancing should be performed by a
qualified dealer.
5. Reinstall blade. See Figure 5.15. Torque blade
mounting bolts to recommended range of 70 to 80 ft.
lbs.
FIGURE 5.14
WEAR LIMIT
(NOTCH STARTS)
DANGEROUS CONDITION!
DO NOT USE ON MOWER!
REPLACE WITH NEW BLADE.
NEW BLADE
FIGURE 5.15
BLADE
BLADE
MOUNTING
BOLT
FIGURE 5.16
22
o
TO 28
o
BLADE
ORIGINAL CUTTING EDGE
BLADE
PULLEY
BLADE
MOUNTING
NUT
SPINDLE
ASSEMBLY
CONE
WASHER (2)