Filter
Top Products
15
Section 3 - OPERATING INSTRUCTIONSSection 4 - MAINTENANCE
4.1 INTRODUCTION
To retain the quality of the SNAPPER mower, use gen-
uine SNAPPER replacement parts only. Contact a
local SNAPPER dealer for parts and service assis-
tance. For the correct part or information for a particu-
lar SNAPPER mower, always mention the model and
serial number. SNAPPER recommends returning the
mower to an authorized SNAPPER dealer annually for
inspection and addition of any new devices, which
might upgrade the safety of the mower. For the near-
est SNAPPER dealer in your area, check the yellow
pages under the heading LAWN MOWERS. For
engine parts and service, look for the engine manufac-
turer's dealers under the heading, ENGINES - gaso-
line.
4.2 SERVICE - AFTER FIRST 5 HOURS
4.2.1. CHANGE ENGINE OIL
Change engine oil as follows:
1. Place a 4 quart minimum capacity container under
the end of the oil drain hose.
2. Remove the plug at the end of the oil drain hose
and allow the oil to drain. See Figure 4.1.
3. After all the oil has drained, replace the plug, tight-
ening securely. Wipe up any oil that may have spilled.
Dispose of drained oil properly. See Figure 4.1.
4. Fill engine crankcase with new oil. Refer to your
engine owner's manual for oil specifications.
5. Change engine oil filter at every oil change. Refer
to your engine owner's manual for service instructions.
4.2.2. CHECK MOWER BLADE
1. Stop Engine. Remove key. Disconnect spark plug
wire(s) and secure away from spark plug(s).
2. Engage parking brake.
3. Use a hydraulic floor jack or hoist to raise machine
high enough to gain access to the underside of deck.
Secure machine with safety blocks.
4. Check torque of blade mounting bolts. As neces-
sary, torque to 70 to 80 ft. lbs. See Figure 4.2.
5. Check blade for sharpness, wear and damage.
Refer to Section "BLADE WEAR LIMITS".
6. Check blade for straightness.
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine running. STOP engine. STOP
blades. Set brake. Remove key. Remove spark plug
wires and secure away from spark plugs. Engine
and components are HOT. Avoid serious burns;
allow sufficient time for all parts to cool.
!
!
WARNING
Wear heavy leather gloves when handling or
working around cutting blades. Blades are
extremely sharp and can cause severe injury. DO
NOT use a cutting blade that shows signs of
excessive wear or damage. Refer to Section
"MOWER BLADE REPLACEMENT" for proper
blade inspection and service procedures.
!
!
FIGURE 4.1
CHECK BLADE MOUNTING
BOLTS - TORQUE SHOULD
BE 70 TO 80 FT. LBS.
FIGURE 4.2
REMOVE PLUG AT END OF
HOSE TO DRAIN OIL