Filter
Top Products
19
Initial Setup & Assembly
Figure 24. Install Snowthrower
A. Hitch Pin
B. Hair Pin Clip
Figure 25. Lift Rod - Front
A. Lift Rod Assembly
B. Hair Pin Clip
C. Lift Arm
Figure 26. Lift Rod - Front
A. Lift Rod Assembly
B. Hair Pin Clip
C. Lift Arm
Install Snowthrower
CONNECT TO HITCH
1. Position the snowthrower in front of the hitch. Insert
the hitch pin (A, Figure 24) through the snowthrower
and hitch on both sides of the snowthrower. Secure
with a hair pin clip (B). Use the back set of hitch
holes (see inset).
NOTE: The hitch pin (A) goes in between the belt,
NOT below or above it.
B
A
INSTALL LIFT ROD
2. Attach the front of the lift rod assembly (A, Figure 25)
to the lift arm (C). Secure with a hair pin clip (B).
A
B
C
A
B
C
3. Connect the rear of the lift rod assembly (A, Figure
26) to the tractor lift arm extension (C). Secure with a
hair pin clip (B).
NOTE: If necessary, perform the lift rod adjustments
found in the Troubleshooting, Adjustments, & Repair
section.
NOTE: See Lift Lever Kit Installation Instructions for lift
rod installation.