Filter
Top Products
- 14 -
5.2.6.2 Panel Light / Pilot Lamp
Pilot Lamp indicates whether or not generator is generating electricity,
when the engine is driving.
5.2.7 Switch
5.2.7.1 Starter Switch
STOP
When the switch is set to this position, all power will be off.
The switch must be set to this position to remove the key.
RUN
The switch must be set to this position during operation.
<Caution>
Do not leave the switch to this position, while the engine is
stopped.A battery discharges.
START
This position will allow user to start the engine. When a user release the
key, the setting will automatically return to <RUN> position.
PREHEAT
This position will allow generator to preheat the glow plug during startup
in cold environment
5.2.7.2 Emergency Stop button
This button is used to stop the engine in emergency. Keep pressing the
button until the engine comes to complete halt.
<Caution>
Keep pressing the button until the engine stops in several seconds.
After the engine stops, be sure to return the starter switch to the
STOP Position.
5.2.7.3 Circuit Breaker
By turning this circuit breaker switch to ON position, power will be
transferred to the output terminal and to the load side. By turning to OFF
position, it will shut down all power to the load side, preventing overload
and short-circuit, and also breaking the earth leakage.
<Caution>
Do not use this breaker as the ON/OFF switch to the load.