Filter
Top Products
- 10 -
WATER TEMP
5 Equipment
5.1 Monitor Display
This generator is equipped with monitoring function for water/coolant temperature, oil pressure,
battery charge, air filter flow, battery fluid level, and fuel level.
When the equipment is started under normal condition, Oil Pressure and Battery Charge lamps
will flash when the Starter Switch is turned from STOP to OPERATING, and all lamps will go off,
immediately after the engine is started.
When the abnormality is detected either in water temperature or in oil pressure, the
corresponding monitor lamp will flash, and the automatic shutoff shall be engaged.
When the automatic shutoff is engaged, turn the starter switch to STOP position, then restart the
engine. When the automatic shutoff is engaged next time, check all parts of the corresponding
alarm.
5.1.1 Water Temperature Monitoring Lamp (for temperature High)
: Injuries
Close all doors and place locks during operating this equipment, to avoid injuries by
unintentionally touching cooling fan and fan belt.
: Burns
Do not open the radiator cap while operating this equipment or immediately after stopping
the equipment, to avoid sustaining burns from hot vapor.
Do not touch the engine and muffler during operation and immediately after stopping the
equipment, for the temperature can reach extremely high.
When the water temperature reaches 105 degrees Celsius during operation, the water
temperature-monitoring lamp will flash, and the automatic shutoff will be engaged.
When this occurs, check the Coolant reservoir tank, and replenish if needed
(refer to 8-2 Checking coolant / water level).
Danger
Caution