I-5974-3
25
6
出力CH設定/ Output channel select
出力CHをCHに設定します。
Select CH as output channel.
【 入力時の注意 】
出力CHは、4種類から設定可能です。
CH1のみ出力 : [CH]
CH2のみ出力 : [CH]
CH1・2両方出力 : [CH]
出力なし : [CH ](表示なし)
[Precautions on data entry]
The following four combinations of outputs are available:
CH1 output only : [CH]
CH2 output only : [CH]
Output from both CH1 and CH2 : [CH]
No output : [CH ](no indication)
7
出力時間設定/ Output duration select
出力時間を0h00m50s に設定します。
Select the output duration at 0h00m50s.
【 入力時の注意 】
出力時間は、1秒間~24時間まで設定できます。
曲の長さよりも少し長めに設定します。
[Precautions on data entry]
The output duration can be selected within the range of 1
second to 24 hours.
The output duration should be made a little longer than the
playing time of the music piece.
8
決定/ Setting
設定内容を確認した後、決定を押します。
After making sure that the data items selected are correct,
press the SET button.
未設定項目がある場合、液晶画面全体が点滅します。
もう一度設定内容をご確認ください。
① 曜日が設定されていますか?
② メロディNo.が設定されていますか?
③ 出力CHが設定されていますか?
④ 出力時間が0h00m00s になっていませんか?
If there are any data items yet to be selected, the entire
LCD screen will flash. Again check the data items selected.
① Are the days of the week selected?
② Is Melody No. selected?
③ Are output channels selected?
④ Isn't the output duration selected at 0h00m00s?
9
設定終了/ End of setting
モードスイッチを通常に戻します。
通常でない場合、プログラム動作を実行しません。
Turn the MODE switch back to NORMAL.
Unless the MODE switch is selected at NORMAL, the
program will not work.
※
プログラム設定(3.曜日設定~7.出力時間設定)を
途中で中止する時は、キャンセルを押してください。
To abort programming ("3. Day-of-the-week select"
through "7. Output duration select") halfway, press the
CANCEL button.
※
プログラム設定中、試し鳴らしを押すと設定中のメロ
ディを鳴らすことができます。
By pressing the MELODY TEST button during
programming, you can play a melody being selected.