Filter
Top Products
18
Adjustment located on Chain Brake
Inside view of
Chain Brake
5. Turn adjusting screw by hand
counterclockwise until adjusting pin
just touches the stop.
6. Slide guide bar behind clutch drum
until guide bar stops against clutch
drum sprocket.
7. Carefully remove new chain from
package. Hol d chain with the drive
links as shown.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Tip of
Bar
Cutters
Depth Gauge
Drive Links
8. Place chain over and behind
clutch, fitting the drive links in the
clutch drum sprocket.
9. Fit bottom of drive links between
the teeth in the sprocket in the
nose of the guide bar.
10. Fit chain drive links into bar
groove.
11. Pull guide bar forward until chain i s
snug i n guide bar groove. Ensure
all drive links are in the bar groove.
12. Install chain brake making sure the
adjusting pin in positioned in the
lower hole in the guide bar.
Chain
Brake
Lower
Hole
Guide Bar
Adjusting Pin
13. Install chain brake nuts and finger
tighten only. Do not tighten any fur-
ther at this point. Proceed to
CHAIN ADJUSTMENT.
CHAIN ADJUSTMENT
See
CHAIN TENSION
in
ASSEMBLY
sec-
tion.
CARBURETOR ADJUSTMENT
W ARNING:
The chain will be
moving during most of this procedure.
Wear your protective equipment and
observe all safety precautions. The
chain must not move at idle speed.
The carburetor has been carefully set
at the factory. Adjustments may be
necessary if you notice any of the fol-
lowing conditions:
S
Chain moves at idle. See
IDLE
SPEED--T
adjusting procedure.
S
Saw will not idle. See
IDLE SPEED--T
adjusting procedure.
Idle Speed--T
Allow engine to idle. If the chain
moves, idle is too fast. If the engine
stalls, idle is too slow. Adjust speed
until engine runs without chain move-
ment (idle too fast) or stalling (idle too
slow). The idle speed screw is located
in the area above the primer bulb and
is labeled T.
S
Turn idle screw (T) clockwise to in-
crease engine speed.
S
Turn idl e screw (T) counterclockwise
to decrease engine speed.
If you require further assistance or are
unsure about performing this proce-
dure, contact your Sears Service
Centre.