Sears 486.244412 Snow Blower User Manual


  Open as PDF
of 20
 
10
(Right Hand Side View)FIGURE 15
STEP 1: (SEE FIGURE 15)
• Assemble the two angle lock bars together as shown
ingure6,sothatallholesarealigned.Useone3/8"
x 1-1/4" carriage bolt (E) and one 3/8" nylock nut (L).
Be sure to insert bolt from side indicated. Do not
tighten at this time.
• Hold the angle lock bars so that the square holes are
at the top. Insert the straight hook end of the angle
lock spring through the small middle hole in both
angle lock bars.
3/8" x 1-1/4"
CARRIAGE BOLT (E)
3/8" NYLOCK NUT (L)
ANGLE LOCK BARS
ANGLE LOCK
SPRING
STEP 2: (SEE FIGURE 16)
• Insert the round hook end of the angle lock spring up
through the hole in the spring mount bracket.
• Insert the angle lock bars down through the slot in the
channel. Underneath the channel, place a 1" long spacer
(U) on each side of the angle lock bars and insert a 1/4"
x 3-1/4" bolt (A) through the channel, angle lock bars
and the spacers. Secure the bolt with a 1/4" nylock nut
(J). Tighten so that lock bars can pivot freely.
• At this time tighten the 3/8" carriage bolt and hex nut
previously assembled to angle lock bars.
NOTE: When the angle lock bars are pulled back in slot,
the pivot plate should unlock and be free to pivot to the
right or left position.
1/4" x 3-1/4"
HEX BOLT (A)
1" SPACERS (U)
1/4" NYLOCK
NUT (J)
PIVOT
PLATE
ANGLE
LOCK
SPRING
SPRING
MOUNT
BRACKET
CHANNEL
(Right Hand Side View)FIGURE 16
(Top View)
FIGURE 17
STEP 3: (SEE FIGURE 17)
• Using a hammer, assemble a 3/8" palnut (S) onto one
end of the spring mount rod. Insert the other end of
the spring mount rod through the pivot plate using the
rear set of holes. Support the assembled end of the
spring mount rod on a block of wood, and assemble
the remaining palnut onto the other end of the rod.
3/8" PALNUT (S)
PIVOT
PLATE
SPRING
MOUNT
ROD
3/8" PALNUT (S)
STEP 4: (SEE FIGURE 18)
• Assemble a 3/8" x 1-1/4" carriage bolt (E) through
the square hole in the cable mount bracket and
through the square hole in the angle lock bars. (The
carriage bolts should face in opposite directions.)
Using pliers hold the cable mount bracket in position,
angling down towards the L.H. hole in the channel as
showningure15.Securewitha3/8"nylocknut(L).
Tighten.Refertothegureforthecorrectanglefor
the cable mount bracket.
FIGURE 18
(Right Hand Side View)
3/8" x 1-1/4"
CARRIAGE BOLT (E)
3/8" NYLOCK
NUT (L)
ALIGN CABLE
MOUNT BRACKET
WITH L.H. HOLE
ANGLE
LOCK
BARS
FRONT
BLADE ASSEMBLY FOR ALL TRACTORS
 previous next