Filter
Top Products
Powered Walk Behind Mower Part No. 04016067 Rev E © Copyright 6/2005
2
Rover Mowers Ltd
ABN 11 000 257 303
TM
SPECIFICATIONS
• This manual covers several mowers with the following specifications:
- Models 51, 61 - 20” (508mm Cut Width)
- 12 Cut Height Settings
- Model 80 - 22” (560mm Cut Width)
- 15 Cut Height Settings
NB. - Models come with one of a range of engines (refer to the engine manual included in the kit)
- Options are available (and may be included) on the above models e.g.
- Mulch Mowing
- Deflector Mowing
- Remote Air Cleaner
- Powerstart Function
- Self Propelled Function
- etc.
- Details may be included in this manual or on a separate manual included in the Mower Kit.
SETTING UP
• Before using the Mower the following set-ups are required:
ASSEMBLY OF THE GRASS CATCHER
• Locate the catcher handle and align its front lugs with the slots in the top of the catcher and press firmly into position
(refer figure 2).
• Position the catcher top over the catcher bottom, aligning the barbs on the top with the slots in the bottom (refer
figure 2).
• Press firmly down on the catcher top to lock the barbs into slots (refer figure 2).
• Secure the top and bottom halves of the grass catcher together at the front using the two 3/16” screws, washers and
nyloc nuts supplied. Insert the screws from the outside with the washers and nyloc nuts on the inside of the catcher.
FOLDING THE HANDLE
• Locking knobs: by turning these knobs the handle bars can be either locked in the operating position or folded for storage.
• Locking lever: lift the lever to release the handle bars for folding or push the lever closed to lock handle bars in the
operating position. Adjust the tension by turning the lock nut with a 1/2" AF spanner (refer figure 3 A).
ADJUSTING THE HANDLE HEIGHT
• Loosen the two nuts (B) at the base of the handle bars on both sides of the mower using a 1/2" AF spanner (refer
figure 3).
• Move the handle bars to the required position and tighten the handle bars nuts.
ENGINE LUBRICATION AND FUEL
The engine safety precautions, oil and fuel recommendations, operation instructions, adjustments and maintenance is covered in the
engine manufacturer’s manual which is included in the mower kit. Please refer to and adhere to these recommendations.
If you do not have the engine manufacturer’s manual please refer to the nearest engine
manufacturer’s representative for a replacement copy.
The engine is packed without oil or fuel. Please add these as per the engine manufacturer’s recommendations before attempting
to start the engine.
Do not allow any dirt or contaminants to enter the fuel tank or oil filler tube.
CAUTION
POWERSTART OPTION
The battery must be removed from the mower while recharging.
Only use the battery charger indoors where it cannot be affected by weather.
The battery contains a strong acid electrolyte which may cause personal and material damage.
- Do not disassemble, drop or damage the battery.
- Do not incinerate or expose the battery to high heat or a flame or it may explode.
- Dispose of batteries thoughtfully. Refer to your local regulations for battery disposal.
- Replace any leaking battery immediately.
- Clean the battery only with a dry cloth - never use petrol, thinners or other petrochemical.
- Neutralize any electrolyte spills with an alkaline solution.
WARNING
2
3
B
A
6067 Current Artwork 10-2004.indd 5/31/2005, 8:10 AM2