Filter
Top Products
17
Electrical and Fuel Inlet Locations
The 3/4 inch N.P.T. fuel inlet connector (A) and electrical
inlet location (B) are shown below.
The home generator is shipped already attached to its
mounting pad. Unless mandated by local code, a concrete
slab is not required.
Lifting the Generator
The generator has a shipping weight of approximately 605
pounds (274 kg). Proper tools, equipment and qualified
personnel should be used in all phases of handling and
moving the generator.
5XPwMFOHUITPGwQJQFC), supplied by the installer, are
required to lift the generator manually. Insert pipes through
the lifting holes (D) located near the unit’s base.
:PVNBZBMTPMJGUUIFVOJUVTJOHBiIPPLBOEIPJTUwNFUIPE
attached to the lifting pipes, provided that you use a spreader
bar to ensure that the chains or cables DO NOT touch the
generator’s roof.
After unit is in place, fill the lifting holes with the supplied
lifting hole plugs.
WARNING Hazardous Voltage - Contact with power
lines could cause electric shock or burns,
resulting in death or serious injury.
Lifting Hazard / Heavy Object - Could result
in serious injury.
t If lifting or hoisting equipment is used, DO NOT contact
any power lines.
t DO NOT lift or move generator without assistance.
t Use lifting pipes as described in Lifting the Generator.
t DO NOT lift unit by roof as damage to generator
will occur.
A
B
C
D
NOT
FOR
REPRODUC
D
DU
DU
DU
U
DU
DU
D
DU
DU
DU
DUC
DUCTION
TJOH
OH
pes, provid
s, provid
chains or cachains or
place, fill theplace, fill t
plugs.plugs
D
U
U
UC