Filter
Top Products
13
The following command is used for grating installation by Acton part #:
INSTALL
Installs new grating parameters into the non-volatile memory of the
monochromator. Uses the part # of the grating to specify the
parameters.
e.g. 1-120-500 5 INSTALL places a 1200 g/mm grating blazed at
500 nm into the second grating position on #5.
The following commands are used for grating installation by grating parameters:
SELECT-GRATING
Specifies the grating number to be installed 1 - 9.
G/MM
Specifies groove density of grating to be installed in g/mm.
e.g. 1200 G/MM
BLAZE
Specifies the blaze wavelength and units of the grating to be installed
with 7 characters of the user’s choice. Unlike other commands, this
command is issued before the parameters. After the command is
issued, the SD3 responds with “ “ . Seven characters are then entered
(these may be numbers, letters, spaces or special characters).
UNINSTALL
Used to remove a grating and its parameters from the SD3 non-volatile
memory e.g. 3 UNINSTALL