Multiquip DCA-600SSV Portable Generator User Manual


 
PAGE 22 — DCA-600SSV — OPERATION AND PARTS MANUAL — REV. #0 (07/13/09)
DCA-600SSV — GENERATOR CONTROL PANEL
Figure 6. Generator Control Panel
The definitions below describe the controls and functions of
the DCA-600SSV "
Control Panel
" (Figure 6).
1. Pilot Lamp – Indicates that the generator is working
properly.
2. Panel Light – Normally used in dark areas or at night
time. When activated, panel lights will illuminate. When
lit this light will make it easier to read the meters and
gauges. When the generator is not in use be sure to
turn the panel light switch to the OFF position.
3. Frequency Meter – Indicates the output frequency in
hertz (Hz). Normally 60 Hz ±1 Hz .
4. AC Ammeter – Indicates the amount of current the
load is drawing from the generator.
5. AC Voltmeter – Indicates the single phase output
voltage present at the UVWO terminals. .
6. Ammeter Change-Over Switch – This switch allows
the AC ammeter to indicate the current flowing to the
load connected to any phase of the output terminals,
or to be switched off.
7. Voltmeter Change-Over Switch – This switch allows
the AC voltmeter to indicate phase to phase voltage
between any two phases of the output terminals or to
be switched off
8. Panel Light Switch – When activated, this switch will
turn on the luminate the control panel.
9. Voltage Regulator Control – Allows manual
adjustment of the generator’s output voltage
A
V
HZ
6
7
9
5
4
3
2
1
14
AUTO
MANUAL
OFF/RESET
LOW OIL PRESSURE
HIGH COOLANT TEMPERATURE
OVERCRANK
OVERSPEED
ENGINE RUNNING
MOOOOO-20001Q
10
11
12
13
8