Filter
Top Products
30
Section 3: Adjustments
ZT60 & ZT72 Zero Turning Radius Mowers Riding Mowers Accu-Z
®
357-103M
8/26/08
Land Pride
Table of Contents
Deck Level Adjustment (Left Side)
Figure 3-15
Deck Level Adjustment (Right Side)
Figure 3-16
Refer to Figure 3-16:
10. Be sure that the adjuster is free to move up and
down. Tighten the adjuster bolt until the front deck lift
chain on the right side becomes tight. Make sure the
deck stays tight against the 3” support blocks.
11. Tighten the adjuster bolt jam nut to prevent the
adjuster bolt from moving.
12. Turn the four front rod nuts “C” & “D” against their
respective trunnion blocks until they make contact.
Tighten nuts “C” & “D” against the trunnion blocks.
Refer to Figure 3-17:
13. Compress the deck lift assist springs so that there is
1” of space between the front nut and on the spring
and the rear nut on the deck lift block. Typical both
sides.
26698
Left Front Deck
Lift Chain
Rod Nut
“D”
Trunnion
Block
Deck Lift Rod
Rod Nut
“C”
Deck Lift
Assist Spring
24577
Adjuster
5/16” Adjuster Bolt
and Jam Nut
Right Front Deck Lift Chain
Deck
Lift Rod
Trunnion
Block
Deck Lift
Assist Spring
Rod Nut
“C”
Rod Nut
“D”
14. When completed, all chains will be tight, deck will still
be resting on the 3" support blocks and stop handle
will be against the adjusting stop plate with the stop
positioned in the 3" hole.
15. Raise deck fully up until the stop handle catches on
the cross notch in the deck height gauge bar.
16. Remove all 3" support blocks.
Deck Lift Assist Spring Adjustment
Figure 3-17
Deck Cutting Height Adjustment
Refer to Figure 3-14 on page 29:
Deck height is adjustable from 1/2” to 4 1/2” in 1/4”
increments. The holes in the height adjusting bar are
spaced at 1/2” intervals. By turning the height adjusting
stop around, 1/4” increments can be attained due to the
1/4” plate that is part of the stop.
EXAMPLES:
• When the height adjusting stop is placed in the 1/2”
hole, with the 1/4” plate facing to the front of the unit,
the cutting height is at 1/2”. When the height adjusting
stop is placed in the 1/2” hole, with the 1/4” plate on the
operator’s side of the hole, the cutting
height is at 3/4”.
• When the height adjusting stop is placed in one of the
holes, with the 1/4” plate on the operator’s side of the
hole, the deck height will be set at one of the following:
3/4”, 1 1/4”, 1 3/4”, 2 1/4”, 2 3/4”, 3 1/4”, 3 3/4” or 4 1/4”.
• When the height adjusting stop is placed in one of the
holes, with the 1/4” plate facing to the front of the unit,
the deck height will be set at one of the following:
1/2”, 1”, 1 1/2”, 2”, 2 1/2”, 3" 3 1/2" 4" or 4 1/2".
The notch located at the rear of the right height adjusting
bar is used when the deck is placed in the transport
mode.
23928
1” Between nuts
Nuts
Deck Lift Chain
Deck Lift
Assist Spring
Trunnion
Block