Filter
Top Products
12
Section 1: Assembly & Set-up
ZT60 & ZT72 Zero Turning Radius Mowers Riding Mowers Accu-Z
®
357-103M
8/26/08
Land Pride
Table of Contents
Engine Preparations
1. Check engine oil level at the dipstick. Add oil if oil is
below the full mark on the dipstick. Do not overfill.
Refer to engine manual for oil recommendation. Also
see "Engine Oil and Oil Filter" instructions on page 42.
2. Add gasoline with a fuel stabilizer to perform initial
starting operations. See "Fuel System" instructions
on page 41 before adding fuel.
Remove Mower From Crate Floor
1. Make a ramp in front and level with the crate floor to
be used for driving the mower off.
2. Check under the mower to make sure it is not banded
to the crate floor. Remove any bands that are still
present.
3. Following all precautions and operating information
provided in "Section 2: Operating Procedures"
before starting and driving the mower off.
4. Raise the deck fully up.
5. Start the engine and drive the mower forward off the
crate floor.
6. Make necessary adjustments to the mower as
outlined in "Section 3: Adjustments" beginning on
page 23.
NOTE: Mowers areshipped fromthe factory withthe
fuel tank
s empty.
IMPORTANT: Thoroughly read and understand
"Section 2: Operating Procedures", pages 13 to 21
before starting and moving the mower.