Filter
Top Products
16
RCB6010 & RCB6015 (540 RPM) and RCMB6010 & RCMB6015 (1000 RPM) Rotary Cutters 318-263M 9/04/08
Land Pride
Section 1: Preparation and Set-up
Table of Contents
Unhooking From the Cutter
1. Park cutter on a level solid hard surface. Place tractor
gear selector in park and set park brake.
2. Refer to “Transporting The Cutter”, Figure 2-1 &
Figure 2-2 on page 18. Raise wings up in the
transport position and place transport lock bars in
the locked position. Make sure transport bars are
secured in place with lock pins (#2) and hair pins
(#1).
3. Remove stroke control spacers from the center
hydraulic cylinder and lower cutter until front skids
are resting on the ground. Replace stroke control
spacers as needed to support wheels at this
position.
4. With tractor gear selector in park and park brake set,
shut tractor engine off, and remove switch key. Move
cylinder lift levers back and forth to release hydraulic
line pressure.
5. Refer to “Hitch Assembly Illustration” (Figure 1-2) on
page 12. Remove the parking jack (#3) from the left
hand wing deck or weight box and install to cutter
hitch. Secure the parking jack in place with attached
jack pin (#4).
6. Adjust the parking jack as needed to remove the
hitch pin.
7. Remove hitch pin and unhook hydraulic hoses from
tractor. Store hose ends on cutter deck.
8. Lower the parking jack to rest cutter on its front skids.