Filter
Top Products
20
Section 4: Maintenance & Lubrication
PR1660, PR1672 & PR1690 Powered Rakes 314-216M
10/20/06
Land Pride
Table of Contents
Storage
At the end of the working season or when the Powered
Rake will not be used for a long period, it is good practice
to clean off any dirt orgrease that may have accumulated
on any of the moving parts.
Check roller studs for wear and replace if necessary.
Inspect Powered Rake for loose, damaged or worn parts.
Adjust and tighten loose parts or replace if needed.
Lubricate as noted in “Lubrication” on page 21.
Repaint partswhere paint is worn or scratched to prevent
rust.
Drain gearbox and chain case oil. Drain oil in gearbox by
removing bottom drain plug. Drain oil in chain case by
removing large cover (#1) Figure 3-3. Be sure to refill
gearbox and chain case at this time. See “Lubrication”
on page 15.
Apply a light coat of grease to any exposed hydraulic
cylinder rods.
Store Powered Rake in a clean, dry place.