Filter
Top Products
16
6. Fit the mounting post (on the back of the sensor) into the receptor of the
mounting bracket.
B. MOUNTING WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the back of the mounting bracket
and the mounting surface to ensure a secure hold. The mounting surface
should be smooth and flat.
2. Remove the protective strip from one side of the tape. Press firmly onto the
designated area on the back of the mounting bracket.
3. Remove the protective strip from the other side of the tape, and situate the
mounting bracket. Firmly press the mounting bracket onto the mounting
surface.
4. Fit the mounting post into the receptor of the mounting bracket.
II. THE WEATHER CENTER
1. Using a straightedge, horizontally mark 3 screw positions with a pencil.
The screw positions should be spaced 3 5/8 of an inch (94mm).
2. Install 3 mounting screws (not included) into a wall within range, leaving
approximately 3/16 of an inch (5mm) extended from the wall.
3. Place the Weather Center onto the screws, using the hanging holes on the
backside. Gently pull the Weather Center down to lock the screws into
place.