Filter
Top Products
Model: WS-1517 www.lacrossetechnology.com/support 18
Ground Mounting: Place at least 6 feet up on a pole in an open area. Higher is better. The wind sensor should be
the highest item in the immediate area. Mount the wind sensor away from all obstacles that will block wind activity,
such as trees and houses.
Rain
Make sure that the rain sensor is level. Look inside; there is a built-in level to assist in mounting. Make sure the
bubble is centered in the level.
Place the protective screen over the top to protect the rain sensor from the debris.
Where practical, mount the rain sensor in place with wood screws (not included).
Make sure that the rain sensor is in open area where precipitation falls directly into the sensor’s bucket, ideally 3-6
feet above the ground.
Note: The rain sensor will need to be cleaned of debris on a regular basis. Mount in an accessible area.
The rain sensor should be placed in an open area away from the walls, fences, trees and other coverings
this may reduce the amount of rain falling into the bucket. Additionally, trees and rooftops may be sources
of pollen and debris that may clog the rain sensor.
To avoid the rain shadow effects, place the rain sensor horizontally, at a distance about two to four times the height of
any nearby obstruction.
Be aware of other wireless rain gauges in the area that may cause interference.
The Rain Gauge is self-emptying and can be left out all year or stored in the winter. If stored for the winter, remove the
batteries to avoid leakage.
Thermo-hygro
The remote thermo-hygro sensor should be placed in the area with a free air circulation and sheltered from direct
sunlight and an extreme weather conditions.
While the thermo-hygro sensor is weather resistant, avoid submersion in water or snow.
We recommend that you mount the outdoor temperature sensor on an outside North-facing wall.
The remote thermo-hygro sensor can stand vertically on a flat surface or mounted on the wall in vertical position
Use screws when mounting the thermo-hygro sensor on the wall
Avoid placing the thermo-hygro sensor near sources of heat such as chimneys and heating elements.
Avoid areas that collect or radiate heat from the sun, such as metal, brick/concrete structures, paving or patio decks.
Position the Weather Station
Make sure that the weather station is locating within the operating range of all remote sensors.
Mount the remote sensors within the line of sight of the weather station.
Transmission range may be affected by trees, metal structures and electronic appliances.
Test reception before permanently mounting all the remote sensors.
Mount near an exterior wall with the front or back facing toward Ft. Collins, Colorado for best WWVB reception.
Avoid placing the weather station in the following areas:
Direct sunlight and surfaces emitting and radiating heat, such as heating ducts or air conditioners.
Areas with interference from the wireless devices (such as cordless phones, radio headsets, baby listening devices,
etc.) and electronic appliances.
Care and Maintenance
Do not mix old and new batteries
Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries
Always purchase the correct size and grade of battery most suitable for intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery installation.
Ensure the batteries are installed with correct polarity (+and -).
Remove batteries from equipment which is not to be used for an extended period of time.
Remove expired batteries promptly.