Filter
Top Products
TP-6843 1/13 Section 3 VSC Controller Operation 25
3.2.3 LCD Display
The controller is equipped with a two-line x
16-character backlit digital display with adjustable
contrast. When the generator is running, the controller
automatically scrolls through the displays shown in
Figure 3-5. The VSC controller measures and
displays the average DC output voltage on the
auto-scrolling display. When the system is in standby
mode and the controller is in AUTO, the screens
shown in Figure 3-6 are displayed.
When a fault or warning condition exists, the controller
will show the corresponding message. See Section
2.6 for more information about faults.
Controller menus display power system information,
including status information for the engine, generator,
and optional RBUS accessories, exercise settings,
and event history. Some menus allow changes to the
controller settings. See Sections 3.7 through 3.18 for
menu diagrams.
Figure 3-5
Figure 3-5 Autopaging Displays, Generator Running
The display contrast is adjustable. Navigate to the
Genset System menu and step down to the Contrast
screen. Press the Select button, and then use the up
and down arrow buttons to adjust the contrast. See
Section 3.5, Changing Settings, and Section 3.14,
Genset System Menu.
The display backlight turns off after about a minute of
no activity. The backlight turns on when a button is
pressed or when the generator set starts.
Figure 3-6
Figure 3-6 Autopaging Displays, Automatic Mode
Genset Status
Running
Voltage: 54V
Load: 73%
Engine: 125F
Oil Pressure: Okay
Battery
13.3V
Engine Runtime:
100.6 h
Date: 02DEC2011
Time: HR:MNpm
Active Alert
Sample data shown.
tp6804
Battery
13.3V
Engine Runtime:
100.6 h
Date: 02DEC2011
Time: HR:MNpm
Next Maintenance:
150 h or Mar2012
Sample data shown.
Genset Status
Standby
Active Alert
Next Exercise:
09:00p 09Dec2011