Filter
Top Products
14 Section 1 Descriptions and Service Views TP-6843 1/13
◦ Backlit display with adjustable contrast for
excellent visibility in all lighting conditions
• Scrolling system status display
◦ Generator set status
◦ Voltage and percent load
◦ Engine temperature
◦ Oil pressure
◦ Battery voltage
◦ Engine runtime hours
• Date and time displays
• Smart engine cooldown senses engine temperature
• Digital voltage regulation: ±1.0% RMS no-load to
full-load
• Automatic start with programmed cranking cycle
• Programmable exerciser can be set to start
automatically on any future day and time, and run
every week or every two weeks
• Three exercise modes
• Front-access mini USB connector for SiteTech
™
connection
• Integral Ethernet connector for Kohler
®
OnCue
®
• Built-in 2.5 amp battery charger
• Remote two-wire start/stop capability
• Diagnostic messages
◦ Displays diagnostic messages for the engine,
generator, and programmable interface
module (PIM)
◦ Over 70 diagnostic messages can be displayed
• Maintenance reminders
• System settings
◦ System voltage and percent load
◦ Voltage adjustment
◦ Measurement system, English or metric
• Programmable Interface Module (PIM) status
displays
◦ Input status (active/inactive)
◦ Output status (active/inactive)
1.6 Accessories
The following optional accessories are offered for the
6VSG generator sets.
1.6.1 Carburetor Heater
An optional carburetor heater is recommended for
improved cold starting in locations where the ambient
temperature drops below 0°C (32°F). The carburetor
heater prevents condensation and carburetor icing.
The heater requires a continuous source of AC power.
See the generator set Installation manual for more
information.
1.6.2 OnCue
®
Generator Management
System
The Kohler
®
OnCue
®
Generator Management System
allows monitoring and control of your 6VSG generator
set from a personal computer located in your home or
at other remote locations. OnCue
®
can also be
configured to send email or text message notifications
in the event of a generator set fault.
Note: Be sure to obtain the correct version of the
OnCue
®
kit for the VSC controller.
OnCue
®
version 3.1 or higher is required for 6VSG
generator sets.
1.6.3 Programmable Interface Module
(PIM)
The optional Programmable Interface Module (PIM)
provides two programmable inputs and six
programmable dry contact outputs for connection to
customer-supplied equipment. The outputs are
controlled by the VSC controller, and can also be
controlled remotely using the OnCue
®
program.
The PIM is mounted in a NEMA 3R aluminum
enclosure, which can be mounted indoors or outdoors.
See the installation instructions provided with the PIM.
1.6.4 Communications Kit
The optional communications kit includes the following
factory-installed items:
• Interface board with factory-set inputs and outputs
and customer connection terminal blocks
• Fuel pressure switch
• Enclosure intrusion alarm switch