John Deere SB1154 Snow Blower User Manual


 
ASSEMBLY
OM 0369SB1148-A 24
Figure 21
SB1154
SB1164
Figure 20
SB1148
Driveline Installation
(Figures 20 -21)
SB1148
(Figure 20)
1. Separate the snowblower from the three
point hitch.
2. Remove paint from snowblower gearbox
shaft (item 2) and grease driveline sliding
surfaces and yoke.
3. Insert the 1/4" x 1/4" x 1 1/4" key (item 1) on
the gearbox shaft. Connect the Ø1" driveline
yoke to the gearbox shaft (item 2). Secure
with a 1/4" NC x 2 1/2" bolt, a 1/4" NC nylon
insert locknut and a 1/4" NC x 3/8" setscrew
(items 3-4-5). Tighten the bolt according to
the Torque Specification Table on page 50.
4. Attach safety chain (item 6) over the upper
link (item 7) to prevent the guard from
spinning.
SB1154 – SB1164
(Figure 21)
1. Separate the snowblower from the three
point hitch.
2. Remove paint from snowblower gearbox
shaft (item 1) and grease driveline sliding
surfaces and yoke (item 2).
3. Remove bolts from the driveline yoke and
slide yoke over drive shaft using the sliding
action of the driveline. Make sure the
driveline is well secured to the shaft by
reinstalling the bolts and nuts (item 3-4) in
the order shown. Tighten the bolts according
to the Torque Specification Table on
page 50.
4. Attach safety chain (item 5) over the upper
link (item 6) to prevent the guard from
spinning.