Filter
Top Products
ASSEMBLY
OM 0369SB1148-A 23
Figure 18
NOTE: Before cutting, make sure the two shafts
intersect by at least 7 3/4" when in working
position that is when the snowblower rests on the
ground.
3. Hold the two half-shaft side by side and locate
the "L" length between the two center-to-
center half-shaft universal joints. Mark off the
zone to be cut on both halves opposite each
half-shaft guard as shown on Figure 18
4. Cut off inner and outer guard tubes as well as
the inner and outer telescopic sections.
5. Cut the guard a second time leaving the same
distance between the end of the guard and
the end of the shaft as existed before. To
obtain the proper distance "A" shown on
Figure 19, cut the guard according to the
following table:
DISTANCE A
Male PTO Female PTO
1 3/4" 1 1/4"
6. File down tubes and remove chips.
7. Apply grease to inside of outer telescopic
section.
IMPORTANT: Work with fully guarded shafts
only!
Figure 19
A