Filter
Top Products
ASSEMBLY
OM 0369SB1148-A 19
Installation of Snowblower with Three Point Hitch
(Figure 15)
1. Install the two cat.1 pins (item 1) on the right
and left snowblower hitches in the lower holes
as shown on figure.
2. Attach tractor lower links (item 2) to the hitch
pins (item 1) and secure with the linchpins
(item 3).
3. Attach the tractor upper link (item 4) between
the upper attaching plates (item 6) using the
tractor pin and linchpin (item 5 – not included).
4. Adjust the snowblower using the tractor upper
link so that the snowblower operates parallel to
the ground.
5. Set the tractor anti-sway turnbuckles so the
snowblower does not sway. Be sure there is
no contact with the tires.
CAUTION
Before connecting snowblower driveline to
tractor drive shaft, make sure driveline is not
too long in raised, lowered and middle
position. If the driveline is too long it must be
shortened, to avoid damaged to tractor. See
pages 21 to 23 for instructions.
6. Connect driveline to tractor drive P.T.O.
making sure that the driveline is properly
engaged.
7. Install the eyebolt (item 7) in the upper hole of
the left or right side of the three point hitch by
screwing the eyebolt nut to the top and locking
eyebolt in place with a 3/8" serrated flange nut
(item 8).
Figure 15