Jacuzzi J - 470 Hot Tub User Manual


 
Page 76
J-400
14. Audio Communication Malfunction: Communication between the
control panel and audio system is faulty. Shutdown power to the
spa, wait 3 seconds and restart the spa to reset the communication.
Contact your authorized dealer or service organization.
15. Blinking Heater icon: This icon will blink on and off to indicate that:
The temperature sensor is sensing a -20°F/6°C
difference between the actual and set temperature or;
The temperature sensor is sensing a temperature above
112°F/44°C or the hi-limit temperature sensor is sensing
a temperature above 116°F/46°C.
16. Extended Temperature
Activated:
The spa is set to go up to
104°F (40°C), but it can
be set to reach 106°F
(41°C). To access the
extended temperature you must press the “Up” (on the
Quad Keypad) button and the button D at the same time for 2
seconds. The system will now allow you to raise the temperature to
106°F (41°C) and the LCD display will read “EXTENDED
 (Figure A). To clear this message,
just press the Down button on the Quad Keypad to lower the
temperature below or back to 104°F (40°C).
17. Please Check Filter!
This message will appear when the lter
reminder time has expired (Figure B).
Please remove the Proclear lters and
lter bag for cleaning or replacement.
18. Feature not installed: (Exterior lights)
This message will appear when a
user tries to activate the exterior
lights and they are not installed
(Figure C). To clear the message
press button D to return to Main
Menu.
106
F
Temp.
6:45 PM
Extended Temperature
Activated
UP
C
B
A
D
Figure A
102
F
Temp.
6:45 PM
Please check filter!
Figure B
EXTERIOR
Feature not installed
C
B
A
D
Figure C