Filter
Top Products
Page 15
J-400
Figure F
1. Obtain a at head screwdriver (3/16" x 6" slotted).
2. Place it ush against the middle slot of the
terminal block (diagram 1).
Figure G
1. Firmly press inward and upward
on screwdriver blade, then pivot
upward to open underlying wire
clamp. Hold this position for step 2.
2. Insert power wire into slot A as
shown, then remove screwdriver to
release terminal block clamp and
secure wire in place. Gently pull on
wire after installation to verify it is
clamped tightly into terminal.
L1
L2
Screwdriver Slots
1
2
1
A
Power wire Slots
Side View
Side View