Filter
Top Products
Page 67
J-400
14.1 Cleaning the Filter Cartridges
A programmable “Please Check Filter”
reminder appears on the control panel
display after a specied number days to
remind you to clean the skimmer lter and to
check the polishing bag lter. This reminder
must be reset at each lter cleaning interval.
Refer to Section 12.3 (page 56) for additional
information and programming details. Your new spa is equipped with an
advanced 2-stage ltration system. Fine debris are ltered by the
circulation pump drawing water through the ProClear™ skimmer and
pleated lter cartridge 12 hours (unless programmed otherwise). Large
debris are ltered when either jets pump is running when the spa is in
use or during a programmed lter cycle. These pumps draw water from
footwell suction tting and through a secondary water polishing bag lter
and additional lter. The exclusive footwell “sweeper” suction tting
enhances ltration in the footwell area by creating a “swirling” water
motion to maximize particle agitation and pickup.
To ensure optimum performance, the ProClear II
skimming lter cartridge (A) must be cleaned every
three months and replaced once a year. The secondary
ProClear Plus polishing lter bag (B) should be emptied
weekly and replaced every 3 months. The ProClear II
lter cartridge (C) must be cleaned every three months
and replaced once a year. To accomplish this, refer to the
following lter cleaning procedure.
Note: Do not attempt to wash the polishing lter bag (B)
or it will come apart!
DANGER: TURN POWER TO SPA OFF! TO DECREASE RISK OF
DAMAGED OR ALTERED!
A
B
2.1. 4. 5.
3.
1. Remove power to the hot tub before removing the skimmer
(A) or lter bag cover (B).
2. Remove the polishing bag lid (B) by rotating it counterclockwise
approximately 5 degrees until you feel it unlatch.
3. Remove the polishing bag by reaching into the lter bucket and
gently pulling upward on the blue lter ring (empty lter bag weekly
102
F
Temp.
6:45 PM
Please check filter!
A
C