Filter
Top Products
Page 60
J-400 Series
8. Adjusting Fader Level
Press EQ button (5) repeatedly until
display reads “FADER.” Press VOL Up/
Down button (3) to choose desired set-
ting. A display of “FADER F-R” indicates
center, R01 to 15 indicates rear fade,
F01 to 15 indicates front fade.
Note: Unit returns to volume mode if volume
control is not operated for 3 seconds.
9. Adjusting Beep Level
Press and hold down EQ button (5) for
about 2 seconds until display reads
“BEEP 2ND”, then release. Press VOL Up/Down button (3) to select
either Beep 2ND or Beep on option.
Select Beep on, you can hear “beep” sound when you press all •
buttons.
Select Been 2ND, you can hear “beep” sound when you press the •
button over 1.5 secs.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
10. Adjusting I-VOL Level
Press and hold the EQ button (5) for about 2 seconds, then
repeatedly press until display reads “I-VOL” (Initial Volume Level
Adjustment). Press VOL Up/Down button (3) to choose desired set-
ting (0 to 45) and the I-VOL will be set automatically. This feature
regulates the max volume level during power up. If the volume level
is higher than the initial volume setting when audio unit is turned off,
once the audio unit is switched back on again, the audio unit will
keep the volume adjusted to the preset level. If the volume level is
lower than the initial volume setting when audio unit is turned off, it
will remember the lower level and resume volume at that level when
unit is turned on again.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
11. Adjusting Area
In Radio mode, press and hold the EQ button (5) for about 2
seconds, then repeatedly press until display reads “AREA USA” or
“AREA EUR”. Press VOL Up/Down button (3) to choose desired
setting, then press and hold the BND button (8) for 2 seconds to
conrm selection.
Note: Unit returns to volume mode if volume control is not operated for 3
seconds.
1
2
17
3
98
75
46
10
11
13
15
12
16
14