Filter
Top Products
Page 40
J-400 Series
When a programmed lter/heating cycle activates, the LCD screen
displays the following message:
1*
At any time, you may check the programming of any aspect of any lter/
heating cycle by rst pressing CYCLE
button then moving through
the menu by pressing either CYCLE
or SELECT button. The
programming is changed only by pressing WARMER or COOLER
buttons during this process.
12.3 Adjusting Time of Day
The Sentry control system remembers the time of day even in the event
of a prolonged power outage. However, it may occasionally be necessary
to reset the time of day. For example: if you are not in the Pacic Time
Zone you will want to reset the time for your own time zone. (The
system will automatically adjust to and from daylight savings time.) To
accomplish this, press DISPLAY
, MODE and DISPLAY
buttons within ve seconds each. A number representing the hour will
be displayed, followed by AM or PM. The hour will advance or decrease
each time WARMER or COOLER button is pressed within
ve seconds. Then, press DISPLAY
button again to display the
minutes. Adjust the minutes as necessary by pressing WARMER or
COOLER button. After 5 seconds, the display will return to normal
and save your settings.
12.4 Main Control Panel Lock
To help prevent unauthorized use of your spa, the Sentry controls
incorporate a unique panel locking system which disables the controls on
the panel.
To Lock The Main Control Panel: Press DISPLAY
,
MODE
, and WARMER buttons within ve seconds
each. A padlock symbol will appear on the LCD screen. With
the panel locked, all components are disabled from modications and
the only settings that can be adjusted are the standard and economy
lter/heating modes and time of day. All automatic spa functions will
operate normally.
To Unlock Main Control Panel: Press DISPLAY
MODE
, and COOLER buttons within ve seconds.
The “lock” symbol will disappear. All buttons are now active.
*Note: Number will vary
according to which
lter cycle is being
programmed.
LOCKED
LOCKED