Filter
Top Products
Page 54
J-400 Series
POOR JET ACTION
(see page 29-36)
1. Make certain the jets pump is turned on.
2. Check position of massage selectors.
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty lter (page 43).
WATER IS TOO HOT 1. Reduce thermostat setting (page 17).
2. Switch hot tub to “Economy” mode to turn
heater on only during programmed lter
cycles (page 37).
NO HEAT 1. Check thermostat setting.
2. Keep the cover in place while heating.
3. If “heater on” indicator is lit (page 21), but
no temperature rise is experienced after
a reasonable period of time, contact your
dealer or authorized service center.
FILTER/CIRCULATION
PUMP OFF
1. Verify lter/circulation pump is
programmed to run 24 hours a day (page
38).
2. Filter/circulation pump cycle canceled by
power interruption. Wait 24 hours for hot
tub to reset.
3. Hot tub water is warmer than 95°F (35°C)
and two degrees warmer than the set
temperature. The “Summer Logic” safety
feature has activated. See note on page
39 for details.
Jacuzzi builds the best spas in the industry. Nonetheless, we are always
striving to improve the quality and features of our products. Your input
as a Jacuzzi spa owner is a cherished part of this process. If you have
any comments or suggestions, or if you wish to be informed on any new
products for your spa, please write to us.
CONGRATULATIONS on your good taste and welcome to the happiest
and most relaxed family in the world!