Filter
Top Products
J-200 Series
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit lter
cleaning)
L2 Lock Mode (disables the jets and light buttons to
prevent unauthorized use of spa). Filtration/heating
cycle will continue to operate as programmed in
this mode. The temperature display ashes when this function is
enabled. Example: the “F3” ltration/heating cycle was enabled
prior to choosing lock mode. The spa continues to perform the
“F3” cycle until lock mode is canceled, allowing another cycle to be
selected.
To set a time for the rst ltration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
rst ltration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
Note: Start time is approximate and may vary slightly from day to day.
11.7 Filtration Modes for Spas With Circulation Pump Option
If your spa is not equipped with the circulation pump option, disregard
this section and refer to page 29forltercycleprogrammingdetails.
(Heater automatically turns on during any heat call while in any Standard
mode).
F0 5 minutes of ltration per day (one 5 minute “Blow-Out”
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of ltration per day (one 30-minute cycle every
twelve hours); this is the factory default setting.
F2 1.5 hours of ltration per day (one 30-minute cycle
every eight hours).
F3 2 hours of ltration per day (one 30-minute cycle every
six hours).
(Heater can only turn on during an active lter cycle while in any
economy mode).
F4 1 hour of ltration/heating per day (one 30-minute
cycle every twelve hours).
F5 1.5 hours of ltration/heating per day (one 30-minute
cycle every eight hours).
F6 2 hours of ltration/heating per day (one 30-minute
cycle every six hours).
30