Filter
Top Products
J-200 Series
10.0 Operating Instructions
The spa control system has automatic functions that operate upon
start-up and normal operation to protect the system. Upon power up, the
readout displays the following information:
1. Control panel displays current software
release (3.56 or 5.56 depending on spa
model) then;
2. Control panel displays “888” and all
indicator LEDs are lit, permitting visual
inspection of all display segments and
indicator lights for proper operation.
3. After the initial start-up sequence
ends, the actual water temperature is
displayed. If water temperature at this
time is less then the factory default temperature setting of 100°F
(38°C) and the spa is set to either standard ltration/heating mode
(Sections 11.1-11.2, page 28), the heater will turn on and run until the
water temperature rises to the factory setting, then turn off.
Note: It is common for the heater to turn on after the spa is rst lled
because tap water is often very cold.
10.1 Setting Water Temperature
The spa’s thermostat provides optimum control of
water temperature. The temperature set point (set
temperature) can be adjusted from 65-104°F (18-40°C).
To raise the set temperature, press the WARMER ( )
button. To lower the set temperature, press the COOLER ( ) button.
Note: The rst press of either WARMER ( ) or COOLER ( ) button
displays the set temperature.
10.2 Activate Jet Pumps
The control panel JETS 1 button activates jets pump 1.
The rst press activates low speed, the second press
activates high speed, and the third press shuts jets pump
1 off. The JETS 2 button activates jets pump 2. The
rst press activates high speed, the second press turns jets pump 2 off.
When manually activated, either pump will automatically turn off after 20
minutes.
10.3 Standard Light Operation
The light button activates the foot well light in the spa
when pressed. Pressing the button turns the foot well
light off. When manually activated, the foot well light will
automatically turn off after one hour.
1.
2.
3.
Spas with
Circulation
Pump Option
Spas without
Circulation
Pump Option
2
1
26