Filter
Top Products
English-27
OPERATION
6. Start the engine. When the engine starts,
immediately release the ignition key back
to the run position and adjust the throttle
to approximately 1/2 position.
7. Holding down at least one of the operator
presence levers, engage blades and set
RPM to maximum
8. Set the ground speed lever to the
desired position.
9. Release the neutral lock bail.
IMPORTANT INFORMATION
Do not run the starter for more than
5 seconds each time. If the engine does
not start, wait about 10 seconds before
re-trying.
8011-421
Return to run position
WARNING!
Be sure all persons are clear of
area before engaging the
blades.
IMPORTANT INFORMATION
To prolong spindle bearing and belt life
engage and disengage blades at
approximately ½ throttle.
8011-661
P
resence lever
8011-415
G
round speed lever