Filter
Top Products
6 – English
• Be careful when rounding a fixed object so that the
blades do not hit it. Never drive intentionally over a
foreign object.
• The machine is heavy and can cause very severe
crush injuries. Be extra careful when loading it on a
trailer or truck.
• Be careful when pulling a load or using heavy
equipment.
a. Only use approved tow hooks.
b. Limit the load to what you can manage safely.
c. Do not make sharp turns. Be careful when revers-
ing.
d. Use counterweights or wheel weights when
indicated in the instructions.
Driving on slopes
Driving on slopes is one of the situations where there is
the most serious risk that the driver can loose control or
that the machine tips over, which can cause severe
injuries or be fatal. All slopes require extra care. If you
cannot reverse up the slope or if you feel uncertain avoid
cutting it.
Do as follows:
• Remove obstacles such as stones and branches etc.
• Cut upwards and downwards, not sideways.
• Look out for and avoid driving over furrows, holes or
mounds. On uneven surfaces it is easier for the
machine to tip over. High grass can conceal obsta-
cles.
• Drive slowly. Use small movement on the hydrostat
pedals.
• Follow the manufacturer’s recommendations on
wheel weights or counterweights to increase stability.
• Be extra careful with the grass collector or other
equipment which can alter the stability of the ma-
chine.
• Always drive smoothly and slowly on slopes. Avoid
sudden changes of speed or direction.
• Avoid starting or stopping on a slope. If the tyres
begin to skid switch off the blades and drive slowly
down the slope.
• Avoid unnecessary turns on slopes, and if turning is
necessary turn slowly and gradually, downwards if
possible.
• Do not cut close to edges, ditches or banks. The
machine can suddenly tip over if a wheel goes over
the edge of a drop or a ditch, or if a bank gives way.
• Do not cut wet grass. It is slippery and the tyres can
loose their grip so that the machine slides.
SAFETY INSTRUCTIONS
Be extra careful when driving on slopes.
Cut slopes upwards and downwards, not sideways.
R
I
D
E
R
8
5
0
RIDER
850
R
I
D
E
R
8
5
0
RIDER 850
RIDER
850
RIDER 850
R
I
D
E
R
8
5
0
RIDER
850
R
I
D
E
R
8
5
0
RIDER 850
RIDER
850
RIDER 850
R
I
D
E
R
8
5
0
RIDER
850
R
I
D
E
R
8
5
0
RIDER 850
RIDER
850
RIDER 850
R
I
D
E
R
8
5
0
RIDER
850
R
I
D
E
R
8
5
0
RIDER 850
RIDER
850
RIDER 850