Filter
Top Products
English – 37
MAINTENANCE
Dismantling the belt
Starting point when dismantling the belt:
• No unit attached to the Rider.
• The front of the belt is hung around the hook
guard’s handle.
The method of disengaging the front section of the
belt from the front pulley is described in steps 5–8
under “Removing the cutting unit”.
The entire belt is only dismantled as set out below,
when the snow plough is fitted on the Rider.
1. Dismantle the steering plate under the support
wheel. Use two 13 mm socket spanners.
2. Unhook the spring on the blade brake.
3. Pry off the belt from the intermediate pulley and
remove the belt.
Removing the attachment frame
Starting point for removing attachment frame:
• Cutting unit must be removed.
1. Release the catch so that the front mounting can
be lifted clear of the cutting unit.
2. Slide the attachment frame backwards so that
the tongue on the cutting unit is clear of the slot
in the attachment frame, then lift off the frame.
Refit in reverse order.