Filter
Top Products
English – 31
5. Hook the rear end of the height adjustment arm
(E) in place:
Set the cutting height lever to the forward
position. Release the pressure from the arm if
necessary by lifting or pushin down on the front
of the frame.
6. Disconnect the belt adjuster spring and fit the
belt over the front pulley. The new belt will be
shorter. If necessary, fit a spanner over the
centre bolt and turn the front pulley.
7. Hook on the belt adjuster’s spring again.
MAINTENANCE
4. Slide in the unit so that the inner pins (B)
bottom in the attachment frame’s groove.
Note!
Check that the belt is fitted around the
tension roller.
Belt diagram
1. Drive belt
2. Front pulley
3. Tension roller
4. Belt adjuster spring
E
B
2
3
4
1
WARNING!
Watch your fingers. Do not turn
the blades or belt.
8. Refit the nose.