Filter
Top Products
SERVICE AND ADJUSTMENT
TO REMOVE CABLES, REVERSE ORDER
• BLACK cable first from chassis and then
from the fully charged battery.
• RED cable last from both batteries.
TO ATTACH JUMPER CABLES
• Connect each end of the RED cable to
the POSITIVE (+) terminal on each
battery, taking care not to short against
chassis.
• Connect one end of the BLACK cable to
the NEGATIVE (-) terminal of the fully
charged battery.
• Connect the other end of the BLACK
cable to a good CHASSIS GROUND,
away from the fuel tank and battery.
TO START AN ENGINE WITH A
WEAK BATTERY
WARNING
Lead-acid batteries generate explosive
gases. Keep sparks, flame and smoking
materials away from batteries. Always wear
eye protection when around batteries.
If your battery is too weak to start the engine, it
should be recharged. (See “BATTERY” in the
Customer Responsibilities section of this
manual).
If “jumper cables” are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR MOWER IS EQUIPPED
WITH A 12-VOLT NEGATIVE GROUNDED
SYSTEM. THE OTHER VEHICLE MUST ALSO
BE A 12-VOLT NEGATIVE GROUNDED
SYSTEM. DO NOT USE YOUR MOWER
BATTERY TO START OTHER VEHICLES.