Filter
Top Products
26
MOWING TIPS
• The cutting deck should be properly
leveled for best mowing performance.
See “TO LEVEL DECK” in the Service
and Adjustment section of this manual.
• The left hand side of the deck should be
used for trimming.
• Drive so that clippings are discharged
onto the area that has been cut. Have
the cut area to the right of the mower.
This will result in more even distribution
of clippings and a more uniform cut.
• If grass is extremely tall, it should be
mowed twice to reduce load and possible
fire hazard from dried clippings. Make
first cut relatively high; second to desired
height.
• Do not mow grass when it is wet. Wet
grass will plug the deck and leave
undesirable clumps. Allow grass to dry
before mowing.
• Always operate engine at full throttle
when mowing to assure better mowing
performance and proper discharge of
material. Regulate ground speed by
going slow enough to allow proper deck
cutting performance as well as the
quality of cut desired. When operating
attachments, select a ground speed that
will suit the terrain and give best
performance of the attachment being
used.
OPERATION
begins to run smoothly. Continue to pull
back on the throttle control in small steps
allowing the engine to accept small
changes in speed and load, until the
throttle control is completely in the fast
position. If the engine starts to run
roughly, press the throttle control back
forward to choke the engine for a few
seconds. Then continue to pull the
throttle control back slowly to the fast
position. This may require an engine
warm up period from several seconds to
several minutes, depending on the
temperature.
COLD WEATHER STARTING (50° F and below)
• When the engine starts, slowly pull the
throttle control back until the engine