Open as PDF
Symbols on the mac
ARNING! Chain saws can be
dangerous! Careless or incorrect use can
result in serious or fatal injury to the
operator or others.
Please read the operator’s manual
carefully and make sure you
understand the instructions before
using the machine.
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European
Community’s Directive. The machine’s
emission is speciﬁed in chapter
Technical data and on label.
Chain brake, activated (right)
Chain brake, not activated (left)
is to reduce the pressure in the cylinder
and make starting easier. You should
always use the decompression valve
when starting the machine.
Set the choke control
in the choke position. This should
automatically set the stop switch to the
Adjustment of the oil pump
Other symbols/decals on the mac
hine refer to special
certiﬁcation requirements for certain markets.
Symbols in the operator’
Switch off the engine bef
out any checks or maintenance.
CAUTION! The start/stop switch
automatically returns to run position.
In order to prevent unintentional
starting, the spark plug cap must be
removed from the spark plug when
assembling, checking and/or
Always wear approved protective gloves.
Regular cleaning is required.
Protective goggles or a visor must be
Filling with oil and adjusting oil ﬂow.
The chain brake must be engaged when
the chain saw is started.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.