Filter
Top Products
25
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
No water coming out of Wand
(contd)
Detergent Suction Assembly (the
part which the High Pressure
Hose connects to) is defective
Remove the Gun and Hose assembly from the
front of the unit. Aim water stream away from
electric source. Turn the faucet on. Water should
start to come out of the front of the unit. If no
water comes out, the Detergent Suction Assembly
will have to be replaced. Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Gun/Hose Assembly is defective Attach the Gun/Hose to the front of the unit
with no wand attached to the Gun. Squeeze the
trigger of the gun to ensure that water comes
out of the front of the Gun at a rate equal to the
Garden Hose. If no water comes out of the Gun
it will have to be replaced. Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Trigger will not move Gun Safety Lock in engaged Release Safety Lock as instructed in Manual.
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit is not turned on Press ON/OFF Switch into ON position.
Loose or disconnected Plug Reconnect Plug.
Defective GFCI Plug If the Plug does not work it will need to be repla-
ced. Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Extension Cord length or gauge
incorrect
Use proper Extension Cord as instructed in section
2.
0.
Gun trigger not operating
properly
Contact us at:
cust
omerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Defective Gun Remove the Gun and Hose assembly from the front
of the unit. Aim water stream away from electric
source and switch the unit into the ON position.
If the unit starts and water comes out of the front,
the Gun may need to be replaced. Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Tripped Pressure washer Thermal
Switch
Allow to cool and restart unit.
Defective ON/OFF Switch Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Unit will not stop when trigger
is released
Screen filter is clogged Clean the Screen filter as instructed in the
s
ectio
n 5.4.
Garden Hose is kinked or leaking
water
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.