Filter
Top Products
24
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Gun/Hose - Leaking water Gun/Hose will need to be replaced. Replacement parts
are not available for the Gun/Hose. Email us at:
customerservice@huskypowerwasher.com
for assistance or order online at:
www.huskypowerwasher.com.
Leaking Oil from Pump A small amount of leakage is
normal
If leakage occurs please contact use directly at
customerservice@huskypowerwasher.com.
Leaking water from bottom
of unit
Machine Inlet connection is de-
fective
Check the Machine Inlet at the front of the unit
to ensure that water is not leaking from it. If the
connection is leaking it will have to be replaced.
Contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Pump housing is leaking water Email us at:
customerservice@huskypowerwasher.com
for assistance.
Low pressure Faucet not fully open or unit is not
receiving a full volume of water
Open the faucet all the way.
Not building maximum Pressure Screen Filter is clogged C
le
a
n
the Screen filter as instructed in the section 5.4.
Irregular Pressure Gun or Hose failure Replace Gun and/or Hose. Contact us at:
customerservice@huskypowerwasher.com
or order online at:
www.huskypowerwasher.com.
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Water leaking from either Hose
or Unit
Stop water from leaking before using the unit or
contact us if you need assistance.
Garden Hose length is too long Shorten the length of the Garden Hose. We
r
ecomm
end a maximum length of 25 to 50
feet for City water supply and 30 feet for Well
water supply.
Clogged Nozzle Clean the Nozzle as instructed in section 5.
2.
Air in Pump L
et
Pressure washer run with Gun trigger depressed
and Wand removed until a steady stream of water
is released.
No Wand attached to the front
of the Gun
Attach either the Click-N-Clean
TM
or Turbo
Wand to the gun. (High Pressure in created with
the Wand and not the Gun).
No water coming out of Wand Clogged Nozzle Clean Nozzle as instructed in section
5.2.
Qui
ck Connect is attached
incorrectly
S
ee
se
ction 3.2. To Attach Quick Connect properly,
keep the outer collar of the Quick Connect held back
while sliding the Quick Connect all the way forward
against the Inlet Nipple and then release the collar to
lock it into place. (The collar is spring loaded so if it is
released too soon it will not lock into place).
Sceen Filter is clogged C
lean
the Sceen filter as instructed in section 5.4.
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.