Filter
Top Products
1.34 1.34
MAINTENANCE
Every 50 Hours
Perform routine checks: Refer to DAILY
BEFORE USE.
Check power unit wheel nut torque: Wheel nut
torque setting - 80 Nm (60lbs ft)
Rotary attachment: Inspect the chain couplings
between the cutter headgear boxes. Inspect sprock-
et teeth and chains for signs or wear.
IMPORTANT: PREVENT DAMAGE - If the
chains / countershaft are removed for any reason,
ensure that the cutterhead phasing is correct after
refitting.
Lubrication
Transaxle: Check oil level on dipstick. This
should be level with the hole indicator on the dip-
stick. Top up if necessary with the correct grade of
transmission fluid, refer to SPECIFICATIONS.
Top up fluid should be introduced through the dip-
stick tube.
Cutterhead Gearbox (Rotary Attachment):
Remove filler plug on top of the gearbox and
check oil level. Gearbox should be 3/4 full. If nec-
essary top up with the correct grade of oil, refer to
SPECIFICATIONS.
General: Lightly apply a good quality general
purpose lubricating oil to the following points;
All linkage pivot points
All inner cables
Rear roller quadrant pivot bushes (Verge
Attachment).
Apply a good quality medium grade grease to the
following points:
Front wheels (Rotary Attachments).
Carrier pivot (Verge Attachments).
Cylinder bearing housings (Verge Attachments).
Chain couplings - between cutterhead gearboxes
(Rotary Attachment).