Filter
Top Products
1.21 1.21
Assembling the Cutterhead Attachment
to the Power Unit continued
12. Refit the drive belt from the engine to the
countershaft pulley.
13. Refit the transmission guard to the power unit
and drive cover to the cutterhead.
To remove the cutterhead attachment from the
power unit:
This is achieved by adopting the procedure. ‘To
assemble the cutterhead attachment to the
power unit’ in reverse order.
14. Route the cutterbrake cable from the rotary
attachment over the countershaft pulley shaft
on the power unit, under the support bracket
and secure with a cable tie.
15. Route the cutterbrake cable over the micro
switch bracket (fitted to the side of the
engine) and secure at the same position as the
microswitch wires with a cable tie.
16. From the microswitch bracket route the
cable to follow the cutter clutch cable up
the left hand handlebar to the anchor bracket
and secure the cable adjuster into the bracket
using the two nuts provided, refer to
MAINTENANCE - RUNNING IN
PERIOD - AT FIRST 50 HOURS OF USE
- CHECK CUTTERHEAD BRAKE
CABLE ADJUSTMENT.
17. Remove the pushfix which is secured to the
eye at the end of the cutterbrake cable inner.
18. Fit the cable eye over the pin on the cutter
clutch lever and secure into position with the
pushfix.
19. Adjust the cutterbrake cable, refer to
MAINTENANCE - RUNNING IN
PERIOD - AT FIRST 50 HOURS OF USE
- CHECK CUTTERHEAD BRAKE
CABLE ADJUSTMENT.
20. Refit the transmission guard to the power unit
and the drive cover to the cutterhead.
WARNING: PREVENT ACCIDENTS - Never
operate the mower with the transmission guard
or drive covers removed.
ASSEMBLING THE MOWER