Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 67596
Assembly
This equipment has a spark 1.
arresting mufer included. A spark
arresting mufer is required by law
in California, on some US Forest
Service land, and possibly in other
areas or situations.
Brass Pump
Plug (14A)
Aluminum Pump
Breather Plug
(59A)
Dipstick (60A)
Figure 1
2. Replace the Brass Pump Plug (14A)
with the aluminum Pump Breather
Plug (59A) and Dipstick (60A) before
rst use. The Pump Breather Plug
must be used whenever the pressure
washer is used. The Brass Pump
Plug (without the breather hole)
should be used for transporting only.
Attach the Handle (14) onto the 3.
Frame (17) with the Handle Bolts (15)
and Nuts (16).
Hose
Connection
Water Inlet
Connection
Detergent Inlet
Connection (26A)
Pressure Regulator
Knob (44A)
Figure 2
4. Attach the Hose (18) to the Hose
Connection on the unit. (See Figure
2.)
Pull the Collar at the end of the hose 5.
back and attach the Gun (19) to the
hose.
Screw the Wand (20) onto the Gun 6.
and secure with the grommet.
Choose the right Nozzle (5) for the 7.
job. Pull back the quick connect
collar and push the Nozzle onto the
end of the Wand. Make sure the
quick connect collar locks the Nozzle
in place.
Black• Nozzle -
Low Pressure
This Nozzle is used with pressure
washer detergent.
White• Nozzle -
Wide Spray
This Nozzle can be used to clean
very large areas.
Green• Nozzle -
Medium Spray
This Nozzle can be used to clean
larger areas.