Filter
Top Products
Page 15For technical questions, please call 1-800-444-3353.SKU 67596
Equipment Operation
Do not direct spray
from the pressure
washer at a person or an
animal. The water stream
could cause serious injury.
Use the pressure
washer only on
surfaces able to withstand the
force of the spray.
Replace the non-vented brass oil 1.
plug with the aluminum Pump Breath-
er Plug before rst use. The Pump
Breather Plug must be used whenev-
er the pressure washer is used. The
brass oil plug (without the breather
hole) should be used for transporting
only.
Choose the Nozzle that best meets 2.
the needs of the job. Only use the
Nozzles on surfaces capable of with-
standing the force of the spray. Only
use the Black Nozzle when using
pressure washer detergent. The
power of the other Nozzles will
propel mist back at the operator
and can imbed detergent into the
surface.
Pull back the quick connect collar and 3.
push the Nozzle onto the end of the
Wand. Make sure the quick connect
collar locks the Nozzle in place.
Turn the water supply on and hold 4.
down the Trigger to start the stream.
Be aware that when it is rst started,
the gun will kick.
It is best to start at a low pressure 5.
setting, and adjust the pressure
upwards. Test spray the edge
of the surface to be cleaned rst
to make sure that the stream is
not too strong for the surface. If
the stream damages the surface
turn the Pressure Regulator Knob
counterclockwise to reduce the
pressure. Moving further away from
the surface being cleaned will also
reduce the pressure being applied
to the surface. If the stream is still
too strong. Turn the engine off, turn
the water supply off, discharge the
excess pressure from the gun by
squeezing the Trigger, and change to
a lower pressure Nozzle.
To increase the pressure, turn the 6.
Pressure Regulator Knob clockwise.
WARNING
CAUTION